sloth
07-23-2008, 06:43 PM
I bought a set of Azonic Outlaws, I have a problem with the front wheel. The Bearing isnt sitting in right....
Heres a pic, probably a bit confusing.. but there is a 20mm wide cup that goes over these and its jamming agains the side rather than the rotational bearing part...
http://i170.photobucket.com/albums/u250/ronanstaff/mtb%20parts/azonic%20hub/azonic_hub.jpg
I would bring them back to where I bought them but it was the states..
Anyone recommend a good mechanic? I tried popping out the bearings with a screwdriver, but its not working and only chipping lunps of aluminium off.
The guy in Azonic said I needed some special tools.
Anyone have this problem or know how to fix it?
Heres a pic, probably a bit confusing.. but there is a 20mm wide cup that goes over these and its jamming agains the side rather than the rotational bearing part...
http://i170.photobucket.com/albums/u250/ronanstaff/mtb%20parts/azonic%20hub/azonic_hub.jpg
I would bring them back to where I bought them but it was the states..
Anyone recommend a good mechanic? I tried popping out the bearings with a screwdriver, but its not working and only chipping lunps of aluminium off.
The guy in Azonic said I needed some special tools.
Anyone have this problem or know how to fix it?